If you want to stain or paint the board, it’s best to go ahead and do that before painting/applying vinyl.Īllow finish to cure at least 24 hours before applying a sticky vinyl to it. I could have waited and polyed after the fact, but I thought sealing it before would help prevent bleed through and allow for a more even paint job. So, to prep the wood, I gave it a few coats of poly beforehand. RELATED: How to apply edge banding to plywood Step 2: Pre-Finish the Giant Ruler Boardįor the ruler marks, I was going to use a stencil and paint them on. I cut this with a miter saw, but any saw that can cut wood would work fine for this.īecause I was using ¾″ plywood, I edge banded the sides, but if you’re using a solid board or you don’t mind seeing the edges, this step is totally optional. You can make yours any size you want, but I chose to make mine about 78″ long (which is 6 ½ feet). Step 1: Cut Ruler Board to Lengthįirst, I cut my board to the length I wanted my ruler to be. I felt that paint may be a little “longer lasting.” But honestly, either method would probably be fine for this. My concern with using the actual vinyl stickers was that with excessive handling, over time, they might peel off. However, if you want to, you can do the opposite and remove everything from the vinyl stencil EXCEPT the lines and numbers and actually just stick these vinyl pieces on instead of painting. I used a Cricut Joy machine to cut a vinyl stencil, removed the line marks and numbers, and transferred this “blank” to the board so that I could paint these on. You can make this however tall you want, but I made mine about 78” or 6 ½ feet long. I used a strip of ¾” plywood that was about 7” wide. Some Notes About this Life Size Ruler Project: Ruler Sizeįor this project, all you need is a single board…it can be scrap plywood a 1×6, 1×8, whatever.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |